Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Make sure that all filters are inserted correctly, before you switch the vacuum
cleaner on.
Dust Container:
1. Simultaneously press the release buttons (2) that are situated
on both sides of the suction opening (1) and lift the dust con-
tainer lid (10) as far as it will go, in order to snap the lid. Take
the dust container (4) out.
2. To place the dust container right (4), first place the hook on
the bottom side of the dust container in the notch of the housing.
Dust Filter (Main Filter and Pre-filter):
1. Open the dust container lid (10), as described above.
Turn the main filter slightly counter clockwise until the
frame sticks out of the cog and pull the main filter up
to remove it.
2. While inserting the main filter, turn the frame clock-
wise in order to lock the main filter.
3. To remove the pre-filter press with little pressure form the inner side of the
dust container to push the pre-filter out.
Motor Filter:
1. Simultaneously press the release buttons (2) on both sides
of the suction opening (1) and open the dust container lid
(10).
2. Remove the black filter seal and take the motor filter out.
The polygonal form of the motor filter suits only in one
direction. Place it correctly.
Exhaust Filter:
1. Press the locking clip on the back side of the
vacuum cleaner down and open the filter grille of
the exhaust filter.
2. Remove the exhaust filter with the fixing pin. Place
the filter always with the fixing pin outwards.
All manuals and user guides at all-guides.com
Inserting the Filters
10
Werbung
