Hitachi HT-40S Bedienungsanleitung Seite 3

| INSTALLATION
Be sure to remove all the components from packaging.
1. Take out the platter and platter mat packed separate-
ly: insert the platter into the record guide and fit the
platter mat on it.
2. Place the balance weight, which is packed separate-
ly, onto the rear of the tonearm with numbers facing
toward the head shell.
Platter mat -
Platter ———-.-----
Record guide
3. When a cartridge is not provided, attach your car
tridge to the head shell. Insert the head shell into thi
tip of the tonearm and secure it with the lockin«
screw.
A cartridge may or may not be provided,
depending on the destination.
~-—— Balance weight
Tonearm
Locking screw
"Head shell
pee Cartridge
Fig.
When you do not intend to use your mode!, secure the tonearm to the arm rest. If the tonearm is disengaged from
the arm rest, the power will automatically come on.
Ground termina
PHONO
PHONO input terminals
a
Red plug (marked R)
White plug {marked L)
Fig.
IMPORTANT FOR U.K.:
The wires in this mains lead are coloured in accordance with the following code:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or col-
oured RED.
=3e