Bosch 0.601.511.760 Originalbetriebsanleitung Seite 21

OBJ_BUCH-796-003.book Page 20 Monday, June 22, 2009 2:57 PM
20 | English
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
1 609 929 S88 | (22.6.09)
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Plastic cap
2 Lock-on button for On/Off switch
(GST 135 BCE)
3 On/Off switch
4 Thumbwheel for stroke rate preselection
5 Vacuum connection*
6 Sliding shoe*
7 Base plate
8 Switch for sawdust blowing device
9 Adjusting lever for orbital action
10 Precision-Control button
11 Precision-Control guide cheeks
12 Guide roller
13 Saw blade*
14 Contact protector
15 Stroke rod
16 Dust cover for vacuuming*
17 SDS clamping lever for saw blade release
18 Handle (insulated gripping surface)
19 Vacuum hose*
20 Extraction adapter*
21 Splinter guard*
22 Scale for mitre angle
23 Thumbwheel for pre-tension of base plate
24 Base plate clamping lever
25 Lead for the parallel guide
26 Locking screw for parallel guide*
27 Parallel guide with circle cutter*
28 Centring tip of the parallel guide*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Bosch Power Tools