Sony CFD-676L Bedienungsanleitung Seite 2

Den
Warning
To prevent fire or shock hazard, do
not expose the player to rain or
moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to
qualified personnel only.
Information
For customers in Europe and Saudi Arabia
CLASS 1 LASER PRODUCT
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
This Compact Disc player is classified as a
CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT label is
located on the rear exterior.
About This Manual
The instructions in this manual are for the
CFD-616L and CFD-C626S. Before you start
reading, check your model number. The
CFD-C626S is the model used for illustration
purposes.
introduction
Notice for customers in the United
Kingdom
A moulded plug complying with BS 1363 is
fitted to this equipment for your safety and
convenience.
Should the fuse in the plug supplied need to
be replaced, a 5 AMP fuse approved by ASTA
or BSI to BS 1362, (i.e. marked with @ or Y
mark) must be used.
If the plug supplied with this equipment has
a detachable fuse cover, be sure to attach the
fuse cover after you change the fuse. Never
use the phug without the fuse cover. If you
should lose the fuse cover, please contact
your nearest Sony service station.
IMPORTANT
If the plug supplied is not suitable for the
socket oultets in your home, it should be cut
off and an appropriate plug fitted in
accordance with the following instructions.
The wires in this mains lead are coloured in
accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead
of this apparatus may not correspond with
the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
Do not connect either wire to the earth
terminals in the plug which is marked by the
letter E or by the safety earth symbol + or
coloured green or green-and-yellow.
WARNING
To prevent shock hazard, do not insert the
plug cut off from the mains lead into a socket
outlet. This plug cannot be used and should
be destroyed.