Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Battery charge indicator during operation
The battery charge indicator (4) displays the state of charge of the battery
when the power tool is switched on.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
To charge the battery, plug the charging cable (12) into the port on the bot-
tom of the handle and into the power supply (13). Plug the power supply
(13) into the plug socket.
Battery charge indicator during charging
The battery charge indicator (4) indicates the charging progress. During the
charging procedure, the indicator flashes.
LED
Slowly flashing light 1 x green
Slowly flashing light 2 x green
Slowly flashing light 3 x green
Continuous light 3 x green
During the charging process, the handle of the power tool will heat up. This
is normal. If you are not planning to use the power tool again soon, discon-
nect the charger from the mains. The power tool cannot be used during the
charging process. It is not defective if it does not work during the charging
process. Follow the instructions on correct disposal.
Protect the charger against moisture.
u
The power tool is equipped with an overload protection system. In normal
conditions of use, the power tool cannot be overloaded. In the event of over-
loading, the power tool automatically shuts off the electronics. In such
cases, switch the power tool off and on again.
Changing the tool (see figure B)
Do not use two-sided screwdriver bits that are longer than 25 mm.
u
Insert the screwdriver bit (1) directly into the tool holder (2).
Bosch Power Tools
English | 31
Capacity
60–100 %
30–60 %
10–30 %
0–10%
Capacity
0 – 30 %
30 – 60 %
60 – 100 %
100 %
1 609 92A 84B | (07.12.2022)
Werbung
