Hama Outdoor 20 Bedienungsanleitung Seite 7

Connection:
Connect the enclosed coaxial cable to the antenna.
For receivers without integrated 5V DC power supplies, use the plug-in power supply unit with the
current feed switch (both included) to power the antenna.
Note: If this is the case, an additional connecting cable (IEC terminal to IEC connector) is required.
This cable is not included.
If the receiver has an integrated 5V DC power supply, you can connect the antenna directly to the
receiver input.
DVB-T Receiver
Safety instructions:
The device is not protected against drops or splashes of water. To avoid damaging the device and to
prevent injuries due to short circuits, do not let the product come into contact with rain, moisture or
other liquids. Connect the device only to an electrical socket that has been approved for the device. The
mains socket must always be easily accessible. Never use or open a defective device. Repair work may
only be conducted by an authorised specialist. As with all electronic devices, keep the device out of the
reach of children.
6
DC 9-12V
DVB-T Receiver
Receiver with 5V
direct voltage output
Receiver without 5V
direct voltage output