Werbung
Verfügbare Sprachen
Verfügbare Sprachen
With Windows XP and the Wireless LAN PC Card, proceed as follows to verify
the settings:
Open the Connect to Wireless Network dialog box.
1
Select the Network Name (SSID) of the Access Point from Available
2
Wireless Networks.
If data encryption is enabled for the Access Point, enter the correct
3
Encryption Key (network key) in the Data Encryption (WEP) field.
Click Connect.
4
If the connection is not established, reset the Access Point functions to the
factory default settings as described in Case 6 and then set up the Access
Point functions again as described in the Quick Start Guide.
Is the wireless network connection acting as a network bridge?
(Windows XP only)
Click Start, point to Connect To and click Show all connections.
1
Confirm that the wireless network connection in question is not acting
2
as a network bridge.
If the wireless network connection is configured as a network bridge,
3
right-click the wireless network connection icon and click Remove
from bridge.
Case 3 - I cannot display the Access Point Setup Page
Is the Web browser of the computer used for the Access Point setup
configured to use a proxy server?
Make sure that no proxy setting is enabled for the IP address of
the Access Point.
While the proxy server setting is disabled, it may not be possible to display
other pages except for the Access Point Setup Page.
Example 1: Using Microsoft Internet Explorer
On the Tools menu, click Internet Options.
1
The Internet Options dialog box appears.
On the Connection tab, click LAN Settings.
2
The Local Area Network (LAN) Settings dialog box appears.
If there are dial-up profiles in the Dial-up box, make sure that you
select the Never dial a connection check box.
If the Use a proxy server for your LAN check box is selected (these
3
settings do not apply to dial-up or VPN connections), deselect the check
box and click OK.
8
Werbung
