Westfalia 19 38 47 Bedienungsanleitung Seite 14

Using
1. First make sure the heat gun is switched off and then connect the power plug
to a socket.
2. Press the ON/OFF switch (3) from the position 0 to step I or II.
At step I temperatures up to 350°C are reached and
at step II temperature up to 550°C.
Within a few seconds the heat gun reaches its operating temperature.
3. Heat up the object to be treated. If required, switch to a higher or lower
temperature and direct the nozzle closer to the object.
4. Always switch off the heat gun after work. Please note that the nozzle is still
very hot. Do not place the heat gun close to flammable materials.
Cleaning
 Before cleaning the unit, always disconnect the plug from the power supply
and allow the heat gun to cool down fully.
 Clean the unit with a dry or soft moistened cloth. Never use aggressive
chemicals.
 Keep the air slots and the nozzle clean at all time.
 Do not allow liquids to enter the unit and do not immerse the heat gun into
liquids of any kind.
Operation
10