Bosch GCL 2-15 G Professional Originalbetriebsanleitung Seite 20

20 | English
All operating modes, apart from point operation, can be se-
lected with both automatic levelling or the pendulum lock.
Working with Automatic Levelling
Sequence of actions
On/off switch (9) in position "
Press the laser line operating mode
button (5) once
Press the laser line operating mode
button (5) twice
Press the laser line operating mode
button (5) three times
Press the laser line operating mode
button (5) four times
Point mode can be activated or deactivated regardless of the line mode setting:
Press the laser point operating
mode button (4) once
Press the laser point operating
mode button (4) twice
If the measuring tool is outside of the self-levelling range, the
laser lines and/or points will flash quickly.
If, during work with automatic levelling, you switch to "work-
ing with pendulum lock" mode (on/off switch (9) in position
Working with the pendulum lock
Sequence of actions
On/off switch (9) in position " On"
Press the laser line operating mode
button (5) once
Press the laser line operating mode
button (5) twice
Press the laser line operating mode
button (5) three times
The laser lines continuously flash slowly in "working with the
pendulum lock" mode.
If, during work with pendulum lock, you switch to "working
with automatic levelling" mode (on/off switch (9) in position
On), the first combination option of this mode's indicat-
ors is always activated.
Automatic Levelling
Working with Automatic Levelling (see figures B1–E1)
Position the measuring tool on a level, firm surface or attach
it to the rotating mount (14).
1 609 92A 7L7 | (08.06.2022)
Horizontal line Vertical line
mode
●
On"
Cross-line mode
●
–
–
●
Cross-line mode
●/–
●/–
is always activated.
Horizontal line Vertical line
mode
●
Cross-line mode
●
–
●
Cross-line mode
For work with automatic levelling, slide the on/off switch (9)
to the "
The automatic levelling function automatically levels irregu-
larities within the self-levelling range of ±4°. The measuring
tool has been levelled as soon as the laser beams stop flash-
ing.
If automatic levelling is not possible, e.g. because the sur-
face on which the measuring tool stands deviates by more
than 4° from the horizontal plane, the laser beams will flash
quickly.
If this is the case, set up the measuring tool in a level position
and wait for the self-levelling to take place. As soon as the
Point mode Pendulum lock
mode indicator (3)
● ●
– ●
● ●
– ●
● ●
●/– –
●/– ●
On), the first combination option of this mode's indicators
Point mode Pendulum lock
mode indicator (3)
● –
– –
● –
● –
On" position.
Figure
B1
C1
D1
E1
B1
Figure
F1
Red
Red
Red
F1
Red
Bosch Power Tools