Automatic Switch-Off; Keep-Warm Function; Switching Off The Keep-Warm Function; Wipe Protection - NEFF T16 D56 Serie Gebrauchsanleitung

en Automatic switch-off
There are 2 different ways to switch the kitchen
timer on.
If a hotplate has been
selected.
If a hotplate has not
been selected.
a The indicator lights up.
Use or to set the time.
2.
a The time counts down.
a When the time has elapsed, a signal sounds.
lights up on the timer display. The
the kitchen timer lights up brightly. It switches off
after one minute.
9 Automatic switch-off
If you do not change the settings of a hotplate for a
long time, automatic switch-off will be activated.
When the hotplate switches off depends on the heat
setting selected (1 to 10 hours).
The heat to the hotplate is switched off.
sidual heat indicator ⁠ / flash alternately on the hot-
plate display.
10 Keep-warm function
The keep-warm function allows you to melt chocolate
or butter and to keep food or cookware warm.
10.1 Switching on the keep-warm function
Select the hotplate.
1.
Touch the symbol.
2.
lights up on the heat setting display.
a
11 Wipe protection
Wiping over the control panel while the hob is switched
on may alter settings. Your hob has a wipe protection
function to prevent this.
The main switch is excluded from the wipe protection
function. You can switch the hob off at any time.
12 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
34
Touch twice within
10 seconds.
Touch ⁠ .
indicator for
and the re-
Displaying the time
Select the kitchen timer with
▶
a The time is displayed for 10 seconds.
Setting the correct time
Select the kitchen timer with
1.
Set the required time with
2.
Switching off the timer signal
You can switch the signal off manually.
Touch any touch field.
▶
a The display goes out and the audible signal ceases.
9.1 Continuing cooking after automatic
switch-off
Touch any touch field.
1.
a The display goes out.
Reset.
2.
10.2 Switching off the keep-warm function
Select the hotplate.
1.
Touch the symbol.
2.
lights up on the heat setting display.
a
11.1 Activating wipe protection
Touch .
▶
a A signal sounds.
a The indicator lamp above
a The control panel is locked for 30 seconds.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
→ Page 35
.
.
or ⁠ .
lights up.