Klarstein 10028189 Anleitung Seite 19

Clean the fi lter screen
If the fi lter screen is clogged with dust, and the eff ectiveness of the air conditioning is reduced, be
sure to clean the fi lter screen once every two weeks.
Clean the upper fi lter screen frame
1 Clasp the wedging block of the EVA fi lter screen frame with
hands. Force down from the outside to remove the EVA
fi lter screen frame. Unscrew four screws fi xing the EVA
fi lter screen and the rear housing to remove the EVA fi lter
screen (as shown in the above fi gure) .
detergent (about 40 ℃ / 104 ℉) and dry it in the shade
2 Put the EVA fi lter screen into warm water with neutral
after rinsing clean.
Clean the lower fi lter screen frame
1 Hold the handle of the CON fi lter screen frame, and pull it
outward gently to remove it.
detergent (about 40 ℃ / 104 ℉) and dry it in the shade
2 Put the CON fi lter screen into warm water with neutral
after rinsing clean.
Postseason Storage:
Unscrew the drainage cover, unplug the water plug, and discharge the water in the water pan into
other water containers or directly tilt the body to discharge the water into other containers.
Turn on the machine, adjust it to low-wind ventilation mode, and maintain this state until the
drainage pipe becomes dry, so as to keep the inside of the body in a dry state and prevent it from
mildewing.
Turn off the machine, unplug the power plug, and wrap the power cord around the wrapping post;
install the water plug and the drainage cover.
Remove the exhaust pipe and keep it properly.
Cover the air conditioning with a plastic bag. Put the air conditioning in a dry place, keep it out of
the reach of children, and take dust control measures.
Remove batteries of the remote control and keep them properly.
Note: ensure that the body is placed in a dry place and keep all machine components properly.
19
1
1 Retaining screw
2 Wedging block
3 Wedging block
2
3