Scope Of Delivery; Display Indications And Symbols - VOLTCRAFT VC265 Bedienungsanleitung

Scope of Delivery

Multimeter with spay-cast rubber protection
Probe converter CLA40 (VC280 only)
9V block battery
2 micro batteries (type AAA, VC280 only)
Safety measuring cable
Operating instructions

Display Indications and Symbols

The symbols and indications are different for each model. This is a summary of all possible symbols and
information of the VC200 series.
REL
Auto range
Connect terminal
Low imp.400kΩ
OL
OFF
AC
DC
+
-
mV
V
A
mA
µA
Hz
kHz
MHz
Ω
kΩ
MΩ
nF
µF
38
Delta symbol for relative value measuring (= reference value measuring)
means "automatic measuring range selection"
Graphic notice to select the required measuring sockets
Impedance switching in the V measuring range (10 MΩ to 400 kΩ )
Overload = the measuring range was exceeded
Switch position "Measuring device off"
Battery replacement symbol; please replace the batteries immediately to avoid
measuring errors!
Symbol for the diode test
Symbol for current measurement with probe sensor
Symbol for the acoustic continuity tester
Symbol for the capacity measuring range
Alternating current for voltage and current
Direct current for voltage and current
Polarity indication for current flow direction (plus pole)
Polarity indication for current flow direction (minus pole)
Millivolt (exp.-3)
Volt (unit of electric potential difference or voltage)
Ampere (unit of electric current)
Milliampere (exp.-3)
Microampere (exp.-6)
Hertz (unit of frequency)
Kilo Hertz (exp.3)
Mega Hertz (exp.6)
Ohm (unit of electric impedance)
Kilo Ohm (exp.3)
Mega Ohm (exp.6)
Nanofarad (unit of electric capacity, exp.-9, symbol
Microfarad (exp.-6)
)