Print 3D Choco - Mycusini 2.0 Anleitung

4. Print 3D Choco

4.1 Preparation
4.2 Insert Choco
Select the function "Insert" on the start screen to insert Choco. Follow the
instructions on the display and observe the following notes.
NOTE
•
Insert the refill including the foil with the open side down.
•
The refill must not protrude beyond the marking on the
outside.
•
Gently close the cartridge holder until it stops.
Place the mycusini on a horizontal surface.
Insert the SD card.
Insert the printing table and place the
silicone mat on the printing table.
Connect the power supply unit to a socket.
Connect the other end of the power supply unit
to the mycusini via the power connector
(page 13, item 2, no. 7).
Take a refill and cut the foil slightly around the
refill at the marking. The mycusini Refill Cutter is
particularly suitable for this.
Now simply break the refill in half and insert
one half into the stainless steel cartridge.
EN
15