Tesla Smart Composition Scale SC100 Benutzerhandbuch Seite 3

Before use, insert the batteries:
1.) Open the battery compartment on the underside of the scale.
2.) Insert the batteries, making sure the polarity is correct.
3.) Then close the battery compartment again.
Notes: If „LO" appears on the display, replace the batteries.
How to connect
1.) Switch on the scale - (the scale will automatically switch on when the batteries
are inserted).
2.) Check if the Bluetooth icon flashes on the scale - (if not, remove and the
insert the battery again).
3.) In the app click „Add device". The app should automatically show all devices
in range.
4.) Click on the scale and confirm its addition.
How to weigh yourself
1.) Stand in the middle of the scale.
2.) 0.0 appears on the display.
3.) The scale switches on and is ready for use.
4.) Stand on the scale and wait for your weight to appear on the screen.
Important:
Stand on the scale with your bare feet and make sure they touch the left and
right electrodes located on the scales. Wait until the scale weighs you, then step
off. The results will automatically be sent to your mobile phone. You can look at
detailed data in the app.
To change the weighing unit, press the button located at the bottom of the
scale.
Troubleshooting
1.) If „Lo" appears on the display, replace the batteries.
2.) When Weight is displayed on the LCD but there is no analytical data in the
app or „Err2" is displayed:
Ensure you are barefoot when standing on the scale.
Ensure your feet are touching the electrodes on both the right and left sides.
Ensure you have entered the profile parameters in full.
Ensure the Tesla Smart app shows that the scale is connected.
Ensure that the scale's electrodes are clean.
Ensure that Bluetooth is enabled on your phone.
If none of the above have solved the problem, enter Device Management.
Here, first remove the device and then repeat steps 1-2 to pair the device again.
3