Bauknecht BAR2 KN5V IN Kurzanleitung Seite 8

CLICK & CLEAN - CLEANING THE GLASS
After removing the door and resting it on a soft surface with the
handle downwards, simultaneously press the two retaining clips
(1) and remove the upper edge of the door by pulling it towards
you (2).
1
Lift and firmly hold the inner glass with both hands, remove it
and place it on a soft surface before cleaning it (3).
TROUBLESHOOTING
Problem
The oven does not work
Download the complete Use and Care Guide from docs.bauknecht.eu for more informations about your product
Policies, standard documentation and additional product information can be found by:
• Visiting our website
• Using QR Code
• Alternatively,
booklet). When contacting our After-sales Service, please state the codes provided on your
product's identification plate.
2
Possible cause
Power cut
Disconnection from the
mains
docs . bauknecht. eu
contact our After-sales Service
3
To correctly reposition the inner glass, make sure that the "R" is
visible in the left-hand corner and the clear surface (not printed)
is facing up. First insert the long side of the glass indicated by "R"
into the support seats, then lower it into position (4). Refit the
upper edge (5): a click will indicate correct positioning.
Make sure the seal is secure before refitting the door.
4
Solution
Check for the presence of mains electrical
power and whether the oven is connected to
the electricity supply.
Turn off the oven and restart it to see if the
fault persists
(See phone number in the warranty
5
Model: xxxXXXXxx XXXXXXXXXXXXXX