Control Panel Description; First Time Use - Bauknecht BAR2 KN5V IN Kurzanleitung

Quick guide
THANK YOU FOR BUYING A BAUKNECHT
PRODUCT
In order to receive a more complete
assistance, please register your product on
www . bauknecht . eu/register

CONTROL PANEL DESCRIPTION

1
1. SELECTION KNOB
For switching the oven on by selecting a
function. Turn to the position to switch
the oven off.
2. +/- BUTTON
To decrease or increase the value shown
on the display.
SLIDING RUNNERS AND SHELF GUIDES
Before using the oven remove the protective tape [a] and then
remove the protective foil [b] from the sliding runners.
REMOVING THE SLIDING RUNNERS [c]
Pull the lower part of the sliding runner to uncouple the lower
hooks (1) and pull the the sliding runners upwards, removing
them from the upper hooks (2).
REFITTING THE SLIDING RUNNERS [d]
Hook the upper hooks on the shelf guides (1) then press the
lower part of the sliding runners against the shelf guides, until
the lower hooks are clicking (2).

FIRST TIME USE

1. SETTING THE TIME
You will need to set the time when you switch on the appliance
for the first time: "AUTO" and "0.00" flash on the display.
A
U
T
O
To set the time of day, press buttons
Set the time of day using the
Please note: To change the time of the day afterwards for example
following lengthy power outages, you will need to reset the
time.
2
3. TIME BUTTON
For selecting the various settings:
duration, timer.
4. DISPLAY
5. THERMOSTAT KNOB
Turn to select the temperature you
require.
and at the same time:
and buttons.
Before using the appliance carefully read the Safety
Instruction.
3 2 4
6. LED THERMOSTAT / PREHEATING
Switches on during the heating
process. Switches off once the desired
temperature is reached.
Please note: All knobs are push activated
knobs. Push down on the centre of the
knob to release it from its seating.
2
1
REMOVING AND REFITTING THE SHELF GUIDES
1. To remove the shelf guides, firmly grip the external part of the
guide, and pull it towards you to extract the support and the
two internal pins from the lodging.
2. To reposition the shelf guides, position them near the cavity
and initially insert the two pins into their lodgings. Next,
position the external part near its lodging, insert the support,
and firmly press towards the wall of the cavity to make sure the
shelf guide is properly secured.
2. SETTING THE TONE
Having selected the desired time value, press the time button:
The display shows "ton 1".
A
U
T
O
To select the desired tone, press button
button to confirm.
5 6
1
2
[c]
, then press the time
EN
[d]