Timer Operation; Timer Off - Sharp AY-A07BE Bedienungsanleitung

TIMER OPERATION

TIMER OFF

The unit will turn off automatically according to your setting.
Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12
hours.
Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12
hours, by 1 hour increment.
MODE TEMP.
FAN TIMER
TEMP.
DISPLAY MODE
1H FAN
SWING CANCEL
Example : When you wish to
stop the operation
2.5 hours later.
TIPS ABOUT TIMER OFF OPERATION
When the TIMER OFF is set, the temperature
setting is automatically adjusted to prevent
the room from becoming excessively hot or
too cold while you sleep. (Auto Sleep function)
COOL/DRY MODE:
• One hour after the timer operation begins,
the temperature setting rises 1°C higher
than the original thermostat setting.
HEAT MODE:
(only for models AY-A07BE/AY-A09BE/AY-A12BE)
• One hour after the timer operation begins,
the temperature setting drops 3°C lower
than the original thermostat setting.
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the TIMER OFF (
time as desired.
• The time setting will change as you to press
the button as follows,
0.5H 1.0H 1.5H
Hold the button pressed down for fast setting.
• The orange TIMER lamp (
light.
1
• The unit will generate a beep when it receives
the signal.
• The time setting will count down to show re-
maining time.
TO CANCEL TIMER
Press the CANCEL button.
• The orange
TIMER lamp
(
unit will turn
off.
TO CHANGE TIMER SETTING
Press the TIMER button which you wish to
change, (TIMER OFF or TIMER ON) and
change the time setting.
E-12
) button and set
10H 11H 12H
) on the unit will
DISPLAY MODE
) on the
1H FAN
SWING CANCEL