Werbung
M.-Nr. 07946040
The installation kit with mat. no. 11792060 for the APDR004 stand installation kit contains:
Parts included
Quantity Mat. no.
Designation
1
Stand
1
Front panel
2
Side panel
8
Raised-head screw, 4.8 x 9.5
4
Rubber bumper
4
Tensioning strip
8
Galvanized B6.4 washer
4
M6 x 20 bolt
4
M6 nut
4
S12 plug
4
8.4 washer
4
8 x 65 wood screw
20
Shim
Washer, Ø 1 1/2" (38 mm)
8
Special tool
Quantity Mat. no.
Designation
1
Spirit level for levelling the stand vertically and horizontally
1
Drill
Drill bit, Ø 12 mm
1
1
Open wrench, 13 mm, for M8 nut
2
Open wrench, 10 mm, for M6 nut
1
Torx 20 screwdriver
The "Miele Service Documentation" (MSD) service application is required for all service work
The warning and safety instructions given in the model-specific technical service documentation must be observed.
Service work must be done following the model-specific work instructions.
Installing the stand
The stand may only be used with the following Miele appliances:
UO8250/UG8250/APDR003 = PT8251, PT8251 COP, PT8253, PT8255, PT8257, PDR514 TOP, PDR514 COP,
PDR514 ROP, PDR914
UO8330/UG8330/APDR004 = PT8331, PT8331 COP, PT8333, PT8335, PT833, PDR518 TOP, PDR518 COP,
PDR518 ROP, PDR918
A
Position the stand and mark the hole positions; see Fig. 1.
Observe the minimum safety distances specified on the installation plan.
Leave at least 3/8" (10 mm) between the wall and the side of the tumble dryer.
A
Drill 4 holes with Ø 1/2" (12 mm) and a depth of approx. 2 9/16" (65 mm) in the floor; see Fig. 3.
A
Thoroughly remove any drilling dust from the holes.
A
Push the 4 S12 plugs (1) into the holes so that they fit flush; see Fig. 4.
A
Level the stand vertically and horizontally using the shims (2) and a spirit level; see Fig. 4.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
21 von 48
13.01.2022
Werbung
