Herunterladen Diese Seite drucken

Miele UG 8250 Umbau- Und Montageanweisung Seite 10

Werbung

M.-Nr. 07946040
The installation kit with mat. no. 11792060 for the APDR004 plinth installation kit contains:
Included parts
No.
Mat. no.
Designation
1
Plinth
1
Front panel
2
Side panel
8
Raised-head screw, 4.8 x 9.5
4
Rubber bumper
4
Tensioning strip
8
Galvanised B6.4 washer
4
M6 x 20 hexagonal bolt
4
M6 hex nut
4
Plug S12
4
Washer 8.4
4
Hexagonal-head wood screw 8 x 65
20
Shim
Washer, Ø 38 mm
8
Special tool/s
No.
Mat. no.
Designation
1
Spirit level for levelling the plinth vertically and horizontally
1
Drill
Drill bit, Ø 12 mm
1
1
Open spanner, 13 mm, for M8 nut
2
Open spanner, 10 mm, for M6 nut
1
Torx 20 screwdriver
The "Miele Service Documentation (MSD)" service application is required when carrying out maintenance work
on the appliance
The safety instructions and warnings in the Miele Service Documentation (MSD) for the corresponding model must be
observed.
Work on the appliance must be carried out in accordance with the work instructions.
Installing the plinth
The plinths may only be used with the following Miele appliances:
UO8250/UG8250/APDR003 = PT8251, PT8251 COP, PT8253, PT8255, PT8257, PDR514 TOP, PDR514 COP,
PDR514 ROP, PDR914
UO8330/UG8330/APDR004 = PT8331, PT8331 COP, PT8333, PT8335, PT833, PDR518 TOP, PDR518 COP,
PDR518 ROP, PDR918
A
Position the plinth and mark the hole positions, see Fig. 1.
Observe the minimum safety distances specified on the installation plan.
Leave at least 10 mm between the wall and the side of the tumble dryer.
A
Drill 4 holes with Ø 12 mm and a depth of approx. 65 mm in the floor, see Fig. 3.
A
Thoroughly remove any drilling dust from the holes.
A
Push the 4 S12 plugs (1) into the holes so that they fit flush, see Fig. 4.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
10 von 48
13.01.2022

Werbung

loading

Diese Anleitung auch für:

Ug 8330Apdr003Apdr004