General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PBH 1050 A1 Bedienungs- Und Sicherheitshinweise

Main handle
Hammer drilling in
Concrete: a = 9.853 m / s
h(HD)
Additional handle
Hammer drilling in
Concrete: a = 8.967 m / s
h(HD)
Main handle
Chiselling: a = 12.738 m / s
h(CHeq)
Additional handle
Chiselling: a = 8.278 m / s
h(CHeq)
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level may change with the application
of the tool and in some cases may be higher than
the value specified in these instructions. Regularly
using the electric tool in such a way may make it
easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of work, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can clearly reduce the vibration load through-
out the work period.
General power tool
safety warnings
warnings and all instructions.
Failure to follow the warnings and in-
structions may result in electric shock, fire and / or
serious injury.
Save all warnings and instructions for
future reference.
Introduction / General power tool safety warnings
, K = 1.5 m / s
2 2
, K = 1.5 m / s
2 2
, K = 1.5 m / s
2 2
, K = 1.5 m / s
2 2
Read all safety
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence
of flammable liquids, gases or dust.
Power tools create sparks which may ignite the
dust or fumes.
c) Keep children and bystanders away
while operating a power tool. Distractions
can cause you to lose control.

2. Electrical safety

a) Power tool plugs must match the outlet.
Never modify the plug in any way. Do
not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric
shock.
b) Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock if
your body is earthed or grounded.
c) Do not expose power tools to rain or
wet conditions. Water entering a power tool
will increase the risk of electric shock.
d) Do not abuse the cord. Never use the
cord for carrying, pulling or unplugging
the power tool. Keep cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk
of electric shock.
e) When operating a power tool outdoors,
use an extension cord suitable for out-
door use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
f) If operating a power tool in a damp
location is unavoidable, use a residual
GB/IE 7