HAPRO V10 Anleitung Seite 24

Attention:
Always dry the sunbed after the initialisation procedure.
24
The parameter "1" will appear at the top of the display, and the name of the
parameter "QSENS INITIALISATION" will scroll across the bottom.
Press <START> 1x.
The number "1" will appear at the top of the display and "OFF" will appear at the
bottom.
Press the <PLUS> key to change "OFF" to "ON".
Press <START> to start the initialisation.
The message "INITIALIZING QSENS" will scroll across the display.
Press <STOP> when the two lowest nozzles produce a constant spray of water
mist. The system is now bled.
The number "1" will appear at the top of the display and "OFF" will appear at the
bottom.
Press <STOP> 3x to exit the con guration menu.