HAPRO V10 Anleitung Seite 16

Messages
GENERAL
ERROR
Attention:
If one of the error messages appears on the display, you should stop using the sunbed, unplug the
appliance and contact your dealer.
16
"Not present"
If an option is not available on the appliance, the message "NOT PRESENT" will
scroll across the bottom of the display. This means that the function in question
is not available to use.
Cooling down (appliance / face tanner)
When the appliance or the face tanner is switched o , a mandatory cooling o
period will start automatically.
An hourglass will appear at the top of the display and a number will appear at the
bottom (indicating the remaining cooling o time in seconds).
Doors open
Opening the doors during tanning will activate the pause mode:
• The lamps will switch off automatically.
• The body cooling will remain on (4 minutes).
• Xsens and Qsens will be paused.
• The lift will lower automatically.
The message "PLEASE CLOSE DOORS" will scroll across the display.
If an error occurs, "ERROR" will scroll across the top of the display, and a code will
appear at the bottom.
E1 = Overrule error
E2 = Communication breakdown with the switch mechanism
E3 = Relay error