Control Functions; Stand-Alone Mode; Pause Mode - HAPRO V10 Anleitung

Control functions

Note:
Tanning time will continue to elapse when the appliance is in pause mode.
If the sunbed is switched back on within 4 minutes after pressing <STOP>, the face tanner (only SLi) will
not switch on. The face tanner will restart automatically after a mandatory 4-minute cooling o period.
12
The appliance will switch on automatically if there is no remote start on the
external timer or coin-op. Your dealer can set the remote start.
Coin-op mode + remote start
Press <START> 1x to start the appliance.
Stand alone mode
Press <START> 1x.
The display shows the maximum tanning time (start time). Use the <MIN> and
<PLUS> keys to change the tanning time.
Press <START> 1x to con rm the chosen time. The appliance will switch on and the
tanning time will start.

Pause mode

Press <STOP> 1x during a tanning session to put the appliance into pause mode.
The lamps will switch o . The body cooling will continue operating (maximum
4 minutes). Xsens (optional) and Qsens (optional) will pause. The lift (optional)
will lower.
The display will continue to show the tanning time left and the message "PRESS
START TO RESUME" will scroll across the bottom.
While in pause mode press <START> 1x to switch the sunbed on again or press
<STOP> 1x to switch the sunbed o . This will stop the tanning session and the
sunbed wil start the mandatory 3-minute cooling o period.