Storage Management [Lo6] (Not Possible For Cth63I0) - WIKA CTH65I0 Betriebsanleitung

5. Commissioning, operation
Alternative: keep the HOLD/MAX/MIN/AVE key pressed for 2 seconds; this deactivates
or activates channel 2.
EN
At least one channel is always active!

5.4.5 Storage management [Lo6] (not possible for CTH63I0)

Press the ENTER/MENU key and select Lo6 using the ▲▼ arrow keys (only when the
data logger version has been ordered). Then press ENTER/MENU again. OFF appears
in the lower display line. Now use the ▲▼ arrow keys to start the logger mode with ON.
Confirm selection by pressing ENTER/MENU.
Use the arrow keys ▲▼ to choose between the automatic Auto or manual SPot saving
and confirm by pressing ENTER/MENU. Decide whether to add or create a new log file
by selecting Add and nLo6. When selecting the automatic saving at the end you are
asked to select the measuring interval:
1S = 1 second
5S = 5 seconds
10S = 10 seconds
20S = 20 seconds
30S = 30 seconds
Confirm the input by pressing ENTER/MENU. Use ESC to return to the measuring
mode. Manual saving by means of SPot. Press ESC to save individual measured
values manually.
26
Unit Lin2
Unit Lin2
WIKA operating instructions, models CTH63I0 and CTH65I0
MENU
CAL Chnl
MENU
CAL Chnl
1M = 1 minute
2M = 2 minutes
5M = 5 minutes
10M = 10 minutes
20M = 20 minutes
Lo6
Lo6