1.
3.
2.
Öffnen des Wagens:
1.) Kupplungen und Heizkabel vorsichtig in Pfeilrichtung abziehen.
2.) Einen Schraubenzieher vorsichtig zwischen Wagenboden und Gehäuse schieben und
nach oben drücken, sodass sich die Rastnase löst und ein kleiner Spalt entsteht.
3.) Anschließend mit den Fingern den Wagenboden vom Gehäuse wegziehen, bis sich die
restlichen Rastnasen lösen.
Opening the coach.
1.) Carefully pull out the coupling and the heating cable in the direction of the arrow.
2.) Carefully push a screwdriver between the wagon fl oor and the housing, and push
upwards so that the fi xing element is disconnected and a small gap shows.
3.) Then pull the wagon fl oor away from the housing with your fi ngers until the remaining
fi xing elements disconnect.
Ouverture d'une voiture.
1.) Sortir l'attelage en tirant prudemment dans le sens de la fl èche.
2.) Insérez avec précaution un tournevis entre le plancher du wagon et le boîtier puis ap-
puyer vers le haut pour que le taquet d'arrêt se désengage et qu'une petite fente apparaisse.
3.) Avec les doigts, séparez le plancher du wagon du boîtier jusqu'à ce que les taquets
d'arrêt restant se désengagent.
Decoder 16-pin
10895
!
1.
Ausgangsbelegung / Decoder interface
/ Interface électrique
P
16
LUX
3
4
5
6
Stirnlicht FS 1
7
8
Front light, Drivers cab 1
Avant la lumière, Cabine 1
9
10
12
Stirnlicht FS 2
13
14
Front light, Drivers cab 2
Avant la lumière, Cabine 2
Aux. 1 Rotes Schlusslicht, FS 2
15
16
Aux. 1 Red taillight, Cab 2
Aux. 1 Feu arrière rouge, Cabine 2
Aux. 2 Rotes Schlusslicht, FS 1
17
18
Aux. 2 Red taillight, Cab 1
Aux. 2 Feu arrière rouge, Cabine 1