Installing The Device - Viessmann Bolzano Bedienungs- Und Montageanleitung

INSTALLING THE DEVICE

1) WHERE TO INSTALL:
- This device was designed to be installed in residential premises.
In any other case, please contact your supplier.
- Installation must comply with the standards currently enforced
in the country of use.
- Install the device within minimum distances from obstacles
conditioner, etc...).
- Do not install shelves above the device.
This device should be installed so that the lowest heated rail is at least
VOLUME 2
60 cm
2) HOW TO CONNECT:
- The device must be supplied with 230V, 50Hz;
- The installation must comply with local national regulation;
- If the power cable is damaged or too short, it must be replaced by a
3) MAINTENANCE:
use abrasive products.
VOLUME 1
VOLUME 0
VOLUME 1
VOLUME 2
- 17 -
No electrical device
No electrical device
Electrical device
IPX4 (Standard EN
60335-2-43:2003/
A2:2008)
GB