Preventing Equipment From Falling Over - Pioneer PDK-TS10 Bedienungsanleitung

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Stabilizing on table or floor
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the equipment on a
table or on the floor, use screws
that have a nominal diameter of
6 mm (1/4 inch) and that are at
least 20 mm (13/16 inch) long.
Position of table/floor screws
When stabilizing the stand to a table or the floor, use M6
with a length above 20 mm (13/16 inch).
Unit: mm (inch)
Dimensions
PDP-5050SX
A 575 (22-5/8)
Dimension without speakers
6
En
Min. 20 mm
(13/16 inch)
120
A
(4-23/32)
Plasma Display
PDP-5060HD PDP-4360HD
PDP-4350SX
PDP-506FDE PDP-436FDE
552 (21-23/32) 500 (19-21/32) 478 (18-13/16)
Side View
Using a wall for stabilization
1
Attaching falling prevention bolts (hooks) to
the Plasma Display.
2
Using strong cords or chains to firmly
stabilize it appropriately and firmly to a
wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right
sides.
Note
Use hooks, ropes, chains, and fittings
that are available on the market.
Recommended hook:
Nominal diameter M8
Length 12 to 18 mm (1/2 to 11/16 inch)
1
Hook
2
Cord or chain
Fitting
Caution
• A table or an area of the floor with adequate strength
should always be used to support the Plasma Display.
Failure to do so could result in personal injury and
physical damage.
• When installing the Plasma Display, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as
earthquakes, or of accidents.
• If you do not take these precautions, the Plasma
Display could fall down and cause injury.
• The screws, hooks, chains and other fittings that you
use to secure the Plasma Display to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks, chains and other
fittings after first inspecting the surface carefully to
determine its thickness and composition and after
consulting a professional installer if necessary.
12 to 18mm
(1/2 to 11/16 inch)