Error Description - Zipro Flame WM Bedienungsanleitung

TROUBLESHOOTING
CAUTION! Opening the housing of the device without a prior contact with a manufacturer's
service voids the warranty. If you suspect a failure that requires the housing to be opened,
contact manufacturer's service.

Error description

The device rocks to sides
The saddle or handlebar sway
Noise during use
Noise and uneven operation
Lack of appropriate
resistance during training
Possible causes
The device was placed on an
uneven surface.
There is an object disrupting
the balance under the base of
the device.
The bases have not be
assembled correctly.
Caps on the base have not
been installed and levelled
correctly.
Bolts and knobs of the saddle
column or handlebar column
have not been tightened.
Incorrectly tightened
elements.
Slight humming noise may be heard during operation due to
the inertial movement of the flywheel caused by the nature of
the structure. It does not affect the operation of the device. Any
possible humming noises heard when rotating the pedals
backwards occur for technical reasons and have no negative
consequences.
Bearings damaged.
Resistance adjustment cable
connected incorrectly.
Drive belt loose.
The distance between
the flywheel and
the magnets increased.
Voltage regulator
damaged.
Solution
Place the device on an even
surface.
Remove the object that upsets
the balance.
Assembly the bases correctly.
Level the caps on the rear
base.
Assembly the rear base
correctly.
Level the caps on the rear
base.
Tighten the bolts and knob of
the saddle or handlebar
column.
Contact the manufacturer's
service.
Contact the manufacturer's
service.
Connect the cable correctly as
per the assembly manual.
Contact the manufacturer's
service.
Contact the manufacturer's
service.
Contact the customer service
of the manufacturer's service.
EN
40