Checking The Shock Absorber - Yamaha FT25B Ergänzung Zur Wartungsanleitung

BRKT
SHOCK ABSORBER (ED/ER)
7050
7060
REMOVING THE SHOCK ABSORBER
WARNING
After tilting up the outboard, be sure to
support it with the tilt stop lever. Other-
wise, the outboard could suddenly lower.
NOTE:
Tilt up the outboard and then push-in the
tilt stop lever 1 to support it.
Remove:
• Shock absorber

CHECKING THE SHOCK ABSORBER

WARNING
This shock absorber contain highly com-
pressed nitrogen gas. Before handling the
shock absorber, read and make sure you
understand the following information. The
manufacturer cannot be held responsible
for property damage or personal injury that
may result from improper handling of the
shock absorber.
• Do not tamper or attempt to open the
shock absorber.
• Do not subject the shock absorber to an
open flame or any other source of high
heat. High heat can cause an explosion
due to excessive gas pressure.
• Do not deform or damage the shock
absorber in any way. If the shock
absorber is damaged, damping perfor-
mance will suffer.
Check:
• Shock absorber
Oil leaks/gas leaks/bends/damage →
Replace.
– 71 –
E