Yamaha WaveRunner XLT800 Wartungshandbuch Seite 382

– +
ELEC
INDICATION SYSTEM
Oil level gauge
1. Check:
Oil level gauge
G
Not operating → Replace the multi-
function meter.
Checking steps:
Supply DC 12 voltage to the white
G
four-pin connector (+: red, –: black)
with a battery.
Disconnect the white two-pin connec-
G
tor (blue and black leads).
Connect the blue and black terminals
G
with a jumper lead 1.
G Connect the green and red terminals
with a jumper lead 2.
NOTE:
If the jumper lead is installed for more
than 30 seconds, the display will auto-
matically turn off.
Check the oil level segments is full
G
indicated.
G Remove the jumper lead from the
white two-pin connector.
G Disconnect the jumper lead 2 and
then connect it to green and red termi-
nal again.
G Make sure the oil low level segment
3, oil level warning indicator 4,
" " message 5 and "WARNING"
lamp 6 blink and the buzzer sounds
intermittently.
7-38
E