Yamaha WaveRunner XLT800 Wartungshandbuch Seite 280

JET
PUMP
a
IMPELLER DUCT AND DRIVE SHAFT
2. Install:
G Front bearing
G Drive shaft
NOTE:
Install the front bearing and drive shaft with
a press.
Distance a:
23 ± 0.1 mm (0.91 ± 0.004 in)
3. Install:
Drive shaft (with front bearing)
G
Spacer
G
G Impeller duct
NOTE:
Press the spacer and the front bearing with
a 36-mm deep socket.
4. Add:
EPNOC grease AP #0
G
(between the drive shaft and spacer)
Quantity:
Approximately 1/3 of capacity
5. Install:
Rear bearing
G
Bearing inner/outer race
attachment:
YB-34474
NOTE:
G Press the bearing inner/outer race at the
same time holding the drive shaft and
impeller duct.
G If a bearing inner/outer race attachment is
not available, use a washer or pipe with
an outer diameter of 46 mm (1.81 in) and
an inner diameter of 20 mm (0.79 in).
6-15
E