Optional Parts - Makita EG241A Bedienungsanleitung

15. OPTIONAL PARTS

Wheel Kit Installation
(1) Check the supplied accessories
(2) Tool preparation
Crane or square bar (about 100mm by 100mm)
Pliers
2 sets of spanners (12mm)
(3) Installation procedures
A) Raise the generator about 100mm with the crane or square bar.
B) Install the wheel and stopper in the wheel shaft.
EN
<Stopper section>
FR
Install wheel shaft ⑤ into stopper ① so that wheel ② is inserted between them and fasten with pin ③.
Next, tighten wheel shaft ⑤ and stopper ① with nut ④.
DE
NL
<Non-stopper section>
Install wheel ② and washer ⑧ onto wheel shaft ⑤ and fasten with pin ③.
ES
C) Check that the wheel rotates smoothly.
IT
D) Loosen length adjustment nut ⑨ for wheel shaft ⑤ and bolt ⑩, then align the position of the hole on the
frame with the mounting hole of wheel shaft ⑤ and tighten bolt ⑥ and nut ⑦ to ¿ x this in place.
PT
Tightening torque: 20 to 25N-m (2.0 to 2.5kg-m)
GR
E) Tighten length adjustment nut ⑨ for wheel shaft ⑤ and bolt ⑩ to ¿ x the length of wheel shaft ⑤.
NO
SE
FI
DK
RU
2 0