Custom Coffee Extraction Temperature - Conrad 2377927 Bedienungsanleitung

11. Turn the funnel counterclockwise into the funnel bracket and select the corresponding SINGLE or DOUBLE button
according to the filter size.
When the bean box is not installed, the bean box indicator light will turn red.
Æ
When the grinder function cannot be used normally, the bean box indicator light will flash with three beeps to
Æ
protect the grinder system.
When the grinder has worked continuously for 3 minutes and is used again after less than 6 minutes, the
Æ
machine will automatically disable the grinding function. The grinding function will be automatically re-enabled
after 6 minutes of inactivity.
If you press the GRIND button when the grinder is disabled, the buzzer will sound three times and the GRIND
Æ
indicator light will flash.
Note:
– By default, the bean grinding time is set to a double-cup size and the grinding machine produces about 19 g
of grounds at a grind level of 5-10. This takes approximately 14 seconds.
– If you use a single-cup filter, you need to manually control the amount of ground coffee or reset the grinding
amount to obtain about 13 g of coffee grounds. This will take approximately 10 seconds.
– The taste of the coffee depends on the roasting level and freshness of your coffee beans, and you may need
to experiment with the grind level.
– The bean box does not have a sealing function. To avoid affecting the taste of your coffee, clean the bean box
regularly and store coffee beans in another tightly packed container.
10.6.1 Setting the grinding time:
You can set the grinding time according to your needs.
1. Hold down the GRIND button and wait until the GRIND indicator light and the bean box indicator light start to flash.
The grinder will then start to work.
2. When the desired grinding time has elapsed, release the GRIND button. The buzzer will sound and the machine
will record the preset time. The next time you use the grinder, the grinder will run for this preset time. The machine
can only record grinder times over 5 seconds. Times of less 5 seconds will not be recorded.
Press the ON/OFF+GRIND buttons at the same time to restore the grinder to factory settings.

10.7 Custom coffee extraction temperature

This machine is equipped with a PID temperature control function, which monitors the temperature of the heating
element to heat water and make sure the coffee is extracted at a temperature of 92 °C.
You can adjust the extraction temperature of the coffee. The temperature can be adjusted between 88-96°C in 2°C
increments to meet different taste requirements.
The higher the temperature, the higher the bitterness and lower the acidity.
Æ
The lower the temperature, the lower the bitterness and higher the acidity.
Æ
1. To set the extraction temperature, hold down the ON/OFF and SINGLE buttons for 4 seconds. The machine will
beep and the ON/OFF indicator will start to flash.
2. To adjust the temperature, press the grind button to decrease the temperature and the double-cup button to
increase the temperature.
37