Parts Description; Assembly - Makita EM403MP Originalbetriebsanleitung

Other instructions
1. Always store the machine in locked rooms and
with an emptied fuel tank.
2. Pay attention to the environment. Avoid unnec-
essary throttle operation for less pollution and
noise emissions. Adjust the carburetor correctly.
3. Do not operate the engine with faulty exhaust
muffler.
First Aid
In case of accident make sure that a first-aid
1.
box is available in the vicinity of the cutting
operations. Immediately replace any item
taken from the first aid box.
2. When asking for help, give the following
information:
— Place of accident
— What happened
— Number of injured persons
— Kind of injuries
— Your name
Additional safety instructions
1. To avoid accident, leave more than 15m (50
ft) distance between operators when two or
more operators work in one area. Also, arrange
a person to observe the distance between
operators. If someone or an animal enter the
working area, immediately stop the operation.
2. Only use the cutting tools that are marked with
a speed equal or higher than the speed marked
on the tool.
3. Be sure to remove the cover on the cutting
blade before operation.
Correct combination of the cutting tool and the protector
CAUTION:
Always use the correct combination of cutting tool and protector. The wrong protector may
not protect you from flying debris and stones. It can also affect the balance of the tool and result in serious per-
sonal injury.
Model
EM403MP
EM404MP
EM405MP
EM406MP
Cutting tool
Metal blade
(with nut, cup, and clamp washer)
Nylon cutting head / Plastic blade
Nylon cutting head / Plastic blade
15 ENGLISH

PARTS DESCRIPTION

EM403MP, EM404MP
► Fig.3: 1. Cap 2. Pipe 3. Protector (universal type)
4. Protector extension 5. Cutter
EM405MP, EM406MP
► Fig.4: 1. Cap 2. Pipe 3. Protector (narrow type)
4. Cutter

ASSEMBLY

WARNING:
Before assembling or adjusting
the equipment, switch off the motor and remove
the spark plug cap or battery cartridge. Otherwise
the cutting tool or other parts may move and result in
serious injury.
WARNING:
Before handling cutting blade,
wear protective gloves. During the assembly or
adjustment, your fingers may contact with the cutting
blade and it may cause serious injury.
WARNING:
When assembling or adjusting
the equipment, always put it down. Assembling or
adjusting the equipment in an upright position may
result in serious injury.
WARNING:
Follow the warnings and precau-
tions in the chapter "SAFETY WARNINGS" and
the instruction manual of the power unit.
Protector (universal type)
Protector (universal type) with protector extension
Protector (narrow type)
Protector