Asus ROG Thor Platinum II Schnellstartanleitung Seite 5

Installing your ROG THOR Power Supply Unit
Before installing or removing cables, ensure that the system is turned off, and all power cables for
the system and all attached devices are unplugged.
1. Follow the directions of your chassis manual and secure your ROG THOR power supply unit into your chassis
using the mounting screws.
2. Connect the bundled cables to your ROG THOR power supply unit.
3. Connect the power connectors to your motherboard and peripheral devices according to your preference. You
may refer to the list below to check which devices each power connector can be connected to.
• The power connectors may vary between different models of ROG THOR Power Supply Units.
• Refer to your motherboard's user manual for more information on the location and connecting the
power connectors mentioned below.
Connect the 24-pin or 20-pin Main Power Connector to the motherboard's 24-pin or 20-pin power
•
connector.
Connect the 4+4 pin CPU +12V Power Connector to the CPU power socket on the motherboard.
•
Connect the 4-pin Peripheral Power Connector to peripheral devices if needed.
•
Connect the 6+2 pin PCI-E +12V Power Connector to the PCI-E graphics card.
•
Connect the SATA Power Connector to devices with a Serial ATA interface.
•
4. Connect your ROG THOR Power Supply Unit to a power source using the bundled power cord.
5. Flip the Power Switch to the "I" position to turn on your power supply unit
ROG Thor PSU
ON
OFF
O dB Fan
5