Grasslin topica smart Bedienungsanleitung Seite 95

Menu
OK
Program
OK
New
With Date?
Yes/No
Fig. 27: Programming cycle switching
1. Press the
Menu
2. Select
Program
3. Select and confirm with
New
The number of available program memory slots is displayed briefly (PXXX).
ð
The number of available switching program memory slots is displayed briefly (dXXX).
4. In menu item
With Date?
(ÄChapter "Date-dependent/date-independent programming" on page 85).
5. Select the
Cycle
6. Enter the hours and minutes for the switching time (+/-) and confirm with
7. Enter period ON (+/-) and confirm with
8. Enter period OFF (+/-) and confirm with
9. Select day of the week (⋀/⋁) on which the cycle is to start and confirm with
The days of the week 1 – 5, 6 – 7 and 1 – 7 are set by default. Individual days of the week
can be set (+/-) under menu item "Select days".
10. To create a new switching time, select
To end the cycle, you have to set an
11. Execute the commands for a switch-off time for cycle switching Ä Chapter "Programming an OFF
command" on page 90.
OK
Select FNC
Cycle
Time
9:00
...minutes
OK
Period ON
0:10
...minutes
button.
and confirm with .
OK
.
OK
, specify whether the switching program is to be programmed with a date
function and confirm with
OK
OK
YES
OFF
Days
12345--
Mon – Fri
OK
OK
OK
Period OFF
0:30
...minutes
.
OK
.
.
and confirm with .
OK
command.
OK
OK
Add
switching time?
Yes/No
OK
Priority
High
.
OK
.
OK
EN
95