Default Setting - Monacor DA-8000 Installationsanleitung

Menu item
F-Exit Time exit delay time with full activation
termination of the exit delay with
F-Exit Mode
P-Exit Time exit delay time with partial activation
termination of the exit delay
P-Exit Mode
P-Exit Sounder
Confirm Mode confirmation of the activation
Quick-Set activation with the button "Quick"
Entry 1 Time
Entry 2 Time entry delay 2nd partial time
Ring Time
Bell Delay response delay of the siren
Bell Re-Arms
Bell Mode
alarm triggering in case of tampering
Tamper Ring actions of the siren and deactivated
alarm triggering by actuating a
Panic Mode
PGM 1 Mode
Chan. 1 Mode not relevant for the DA-8000
Alarm Restore not relevant for the DA-8000
Alarm reset authorization and function with simultaneously pressing the buttons 1 + 3
alarm reset authorization in case
Tamper Reset
Alarm Reset alarm reset authorization in case of alarm
Alert Mode function when pressing the buttons 1 + 3
for programming of the alarm control system
for the operators
Number of the events which
Fig. 16 Default setting
Function
Zones
1
2
3
4
5
6
7
8
Function
Entry delay and exit delay
full activation
with partial activation
signal during the exit delay
with partial activation
entry delay 1st partial time
Alarm triggering and panic button
siren time
alarm repeats of the siren
siren type
alarm control system
panic button
Control output PGM1
control output PGM1
of tampering actions
Type*
E/E
Pt E/E
12 Hr
12 Hr
12 Hr
E/E
Panic
12 Hr
*meaning of the settings see chapter 5.1
time = according to the time adjusted
time = according to the time adjusted
Off = no confirmation by the strobelight
SAB (self-actuating bell) = siren without time limit
Off = no alarm triggering by the siren and the strobelight
(only by the buzzers of the keypad controllers
Aud. = siren, strobelight, speaker and buzzers
of the keypad controller respond
SW12V = 12 V are present with activated
Fire, please do not change
Any = resetting is possible with any code
Mast = resetting by the master code only
Access codes
1, 2, 3, 4 (however, if the code was changed to one with a
9 at the beginning, it will not be reset*)
Mode of the log
64 events (with date + time); a change to can be stored
256 events without time indications will not be reset*
* when resetting to the default setting

Default setting

Mode*
Chime
Full
Full
Part1
Part2
Full
Full
Full
30 seconds
30 seconds
Aud. = audio signal
On = is possible
30 seconds
10 seconds
20 minutes
00 seconds
99 times
and the speaker)
alarm control system
Off, please do not change
Panic = panic button
5, 6, 7, 8 (master code 1)
GB
Text
zone 1
zone 2
zone 3
zone 4
zone 5
zone 6
zone 7
zone 8
39