Makita AF550H Betriebsanleitung Seite 7

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency (times/min.)
5. Locking position
6. Released position
7. Lock lever
8. Trigger
9. Contact element
10. Adjuster
11. Too deep
12. Flush
13. Too shallow
SPECIFICATIONS
Pneumatic tool oil
Dimensions (L X H X W)
Min. hose diameter
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
......... Read instruction manual.
......... Wear safety glasses.
..................... Do not use on scaffoldings, ladders.
Intended use
The tool is intended for fastening on interior work and
furniture work.
Pneumatic nailer/stapler safety
warnings
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Explanation of general view
14. Lever
15. Sliding door
16. Magazine
17. Nail
18. Groove for the sliding door
19. Grooves at the bottom of the
magazine
20. Nail discharge opening
21. Front driver guide
22. Nose adapter
23. Protrusion
24. Holder
25. Nose adapter
Model
Air pressure
Nail length
Nail capacity
Net weight
Save all warnings and instructions for
END106-3
future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
General safety
• Do not permit those uninstructed to use the tool.
• No horseplay. Respect the tool as a working
implement.
• Do not operate when under the influence of alcohol,
drugs or the like.
• Never alter the tool.
ENE073-1
Personal protective equipments
• Always wear safety glasses to protect your eyes from
dust or fastener injury.
WARNING: It is an employer's responsibility to
enforce the use of safety eye protection equipment by
ENB110-4
the tool operators and by other persons in the
immediate working area.
For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or fastener injury. The safety
glasses and the face shield should conform with the
requirements of AS/NZS 1336. (Fig. 1)
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
26. Place first the contact element
against workpiece.
27. Hex wrench
28. Rear driver guide
29. Screws
30. Humid
31. Hot
32. Cap
33. Drain cock
34. Thinner
35. Stove
AF550H
0.98 - 2.26 MPa (9.8 - 22.6 bar)
15 mm - 55 mm
100 pcs.
ISO VG32 or equivalent
228 mm X 61 mm X 235 mm
5.0 mm or more
1.3 Kg
7