Inhaltsverzeichnis
Werbung
1
2 3
SHIFT CABLE
1. Check:
Checking steps:
5
4
2. Adjust:
Adjustment steps:
Turn in
Turn out
The cable joint must be screwed in more
than 8 mm (0.31 in).
– 20 –
Reverse gate stopper lever position
Incorrect → Adjust.
Set the shift lever to the reverse posi-
tion.
Check that the reverse gate 1 contacts
the stopper 2 on the bracket and the
lever 3 contacts the reverse gate.
Set the shift lever to the forward posi-
tion.
Check that the lever 4 has been
shifted over the bracket 5.
Shift cable joint
Loosen the locknut 1.
Disconnect the cable joint 2 from the
ball joint 3.
Situate the reverse gate to the stopper
on the bracket and the lever to the
reverse gate.
Turn the cable joint to align it with the
ball joint.
Shortens.
Lengthens.
Turn out the cable joint nine times a
to extend cable 7 mm (0.28 in) from
the aligned position.
WARNING
Connect the cable joint and tighten the
locknut.
Locknut:
3 N • m (0.3 kgf • m, 2.2 ft • lb)
E
Werbung
Inhaltsverzeichnis
