Yamaha WaveRunner XLT1200 Zusammenbauanleitung Seite 50

STEERING CABLE
1. Check:
Jet thrust nozzle clearance a , b
Difference → Adjust.
Checking steps:
Set the control grip in the neutral posi-
tion.
Turn the handlebar lock to lock.
Measure the clearances a and b .
If a and b clearances are not even,
adjust the cable joint.
2. Adjust:
Steering cable joint (handle end)
Adjustment steps:
Set the control grip in the neutral posi-
tion.
Loosen the locknut 1 .
Disconnect the cable joint 2 from the
ball joint 3.
Turn the cable joint 2 in or out for
adjusting clearances a and b .
Turn in
Turn out
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint and tighten the
locknut.
Locknut:
6 N • m (0.6 kgf • m, 4.3 ft • lb)
– 18 –
Clearance a is increased.
Clearance b is increased.
E