Setting The Timer Manually; Priority Rules For Overlapped Presettings - Pioneer KURO PDP-LX6090H Bedienungsanleitung

10 Using the Electronic Programme Guide (EPG)(for DTV/SAT only)

Setting the timer manually

Using the menu, you can also preset digital TV programmes by
specifying their scheduled date and time.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "System Setup" (/ then ENTER).
4 Select "Digital Tuner Setup" (/ then ENTER).
5 Select "Programme Timer" (/ then ENTER).
The schedule table appears.
You can set the timer to the programme numbers where no preset
programmes have been entered (see page 50 for the timer screen).
Select a programme number (/ then ).
6
You can select any desired programme number.
Specify a date (/ or 0 to 9, then ).
7
8 Specify the start hour/minute and end hour/minute
(/ or 0 to 9, then ).
9 Select "Digital" or "Satellite" (/ then ENTER).
10 Specify a channel number (/ or 0 to 9, then ).
11 Register the preset settings after all items are set (ENTER).
If a preset time is in the past or the channel is locked, an alert
message appears.
A yellow triangle icon indicates that the recording/watching may
fail due to overlapped presettings.
If presetting another programme, repeat steps 6 to 11.
You can preset up to 18 programmes.
12 Press HOME MENU to exit the menu.
Note
• You can also display the Programme Timer screen using the
TOOLS Menu. Press TOOLS and select "Programme Timer".
• Preset recording/watching begins immediately when presetting
operations are performed within three minutes of the start of the
programme.
• Presettings made using the EPG are automatically shown in the
scheduled table.
• Recording may fail because of watching restrictions imposed by
the CA module.
52
En

Priority rules for overlapped presettings

When preset TV programmes are overlapped, the following two
rules are used to determine higher priority. If more than one of the
two rules are met, the rules are applied in the order 1 then 2.
Rule 1: If two presettings are overlapped, the presetting with the
earlier start time is given a higher priority. If two presettings
are sequential, the last portion of the first programme or
the first portion of the second may not be recorded.
Rule 2: If presettings with the same start time are overlapped, the
presetting with the bigger list number is given a higher
priority.
Deleting TV programme presettings
To delete the programme(s) preset in the Programme Timer, use the
TOOLS Menu. For editing, follow the procedure below.
1 Select a specific programme to delete.
2 Press TOOLS.
The TOOLS Menu appears.
3 Select "Delete" (/ then ENTER).
A confirmation screen appears.
4 Select "OK" (/ then ENTER).
5 Press TOOLS again to exit the TOOLS Menu.
Note
• To cancel this option before it finishes, select "Cancel" in step 3.
Moving TV programme presettings
To move the programme(s) preset in the Programme Timer, use the
TOOLS Menu. For editing, follow the procedure below.
1 Select a specific programme to move.
2 Press TOOLS.
The TOOLS Menu appears.
3 Select "Move" (/ then ENTER).
4 Select the position to move the selected programme (/).
5 Move the programme to the selected position (ENTER).
6 Press TOOLS again to exit the TOOLS Menu.