Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting up
Chapter 8
Setting up
Setting up TV channels
This section describes how to automatically search for and set up
TV channels.
Using Auto Installation
When the flat screen TV is switched on for the first time after
purchase, Auto Installation menu appears on screen. For language
and channel selections, follow the steps below.
1
Select "Language" (/).
2
Select a language (/).
Language
Country
Terrestrial Tuner
Aerial Power
Satellite Tuner
Satellite Setup
You can select from among 18 languages; English, German, French,
Italian, Spanish, Dutch, Swedish, Portuguese, Greek, Finnish,
Russian, Turkish, Norwegian, Danish, Czech, Ukrainian,
Hungarian, and Croatian.
3
Select "Country" (/).
4
Select the country (/).
5
Select "Terrestrial Tuner" (/).
6
Select a tuner type (/).
Use / to select "Digital", "Analogue", "Both" (default), or "Off".
7
Select "Aerial Power" (/).
This option is available only when you select "Digital" or "Both" in
step 6. Skip steps 7 and 8 when you select other options.
Caution
• When the "Aerial Power" setting is on, directly connect the
aerial to the ANT input terminal at the rear of the flat screen TV.
Connecting any device between the aerial and flat screen TV
may cause damage to the device.
8
Select "On" or "Off" (default)(/).
9
Select "Satellite Tuner" (/).
Use / to select "On" (default) or "Off".
If you select "On", select "Satellite Setup" then press ENTER to move
to the Satellite Setup screen.
If you select "Off", the "Satellite Setup" menu dims.
:
English
:
Austria
:
Both
:
Off
:
On
Start
10 Select "Start" (/ then ENTER).
Auto Installation automatically starts. To quit Auto Installation
before it finishes, press RETURN.
Note
• You can start Auto Installation from the HOME MENU after
moving to another country, for example. Follow the steps below
before starting Auto Installation:
1
Press HOME MENU (/ then ENTER).
2
Select "Setup" (/ then ENTER).
3
Select "System Setup" (/ then ENTER).
4
Select "Auto Installation" (/ then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons 0 to 9. See
Using a password
If no channel is found, check the antenna connections, and then
retry Auto Installation.
Note
• Channels obtained may vary depending on the installation
environment and weather conditions.
Setting up satellite TV channels
manually
You can also set up satellite TV channels manually without using
Auto Installation. For setup details, follow the steps below.
Note
• The "Digital Tuner Setup" option is only available in the DTV/SAT
mode. Press TV/DTV/SAT on the remote control to select the
DTV or SAT mode.
1
Press HOME MENU.
2
Select "Setup" (/ then ENTER).
3
Select "System Setup" (/ then ENTER).
4
Select "Digital Tuner Setup" (/ then ENTER).
5
Select "Installation" (/ then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons 0 to 9. For the password, see
page 60.
6
Select "Satellite Setup" (/ then ENTER).
7
Select "Scan Type" (/ then ENTER).
Use / to select "By Satellite", "All Frequencies" or "SMATV".
08
on page 60.
Using a password
on
29
En
Werbung
Inhaltsverzeichnis
