Herunterladen Inhalt Inhalt Diese Seite drucken

Turning The Power On - Pioneer KURO PDP-LX6090H Bedienungsanleitung

Flachbildfernseher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Watching TV
Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner must
be set up. See Setting up TV channels on page 29 for how to do
this.

Turning the power on

Turn a on on the flat screen TV when the POWER ON and
STANDBY indicators are off (see Part names on pages 12 and
13).
• The system is on.
• The POWER ON indicator lights up blue.
Press a or 0 to 9 on the remote control unit or STANDBY/ON
on the flat screen TV if the STANDBY indicator lights red.
• The POWER ON indicator lights up blue.
• If you press 0 on the remote control unit, images from "INPUT 1"
will be displayed.
• If you press 1 to 9, TV images will be displayed.
Placing the system into standby
Press a on the remote control unit or STANDBY/ON on the flat
screen TV.
• The STANDBY indicator lights up red.
• The system enters the standby mode and the image on the
screen disappears.
Note
• When a on the flat screen TV is off, you cannot turn the power
on by pressing a or 0 to 9 on the remote control unit or
STANDBY/ON on the flat screen TV.
• While the system is placed into standby mode, pressing remote
control's a causes the flat screen TV to turn on.
• When the system is placed into standby mode, the main power
flow is cut and the system is no longer fully operational. A minute
flow of power feeds the system to maintain operational readiness.
• If you are not going to use the flat screen TV for a long period of
time, be sure to remove the power cord from the power outlet.
• If you unplug the flat screen TV from a power outlet, the clock
inside the flat screen TV will reset with certain functions, such as
timer recording, are disabled. After plugging in the flat screen TV
again, clock information is automatically obtained as you tune in
a DTV programme.
If you unplug the flat screen TV from a power outlet when a timer
recording programme(s) has been registered, the flat screen TV
may automatically tune in to the DTV programme in order to
obtain clock information when you turn the power on the next
time.
It may take a short while until the clock information is obtained.
An alert will appear when you try to tune in an analogue
programme before obtaining the clock information.
Flat screen TV status indicators
The table below shows the operational status of the flat screen TV.
You can check the current status of the system with the indicators
on the flat screen TV.
Indicator status
POWER ON
STANDBY
The power cord of the flat screen TV
has been disconnected. Or, the power
cord of the flat screen TV has been
connected but the a button of the flat
screen TV is off.
Power to the system is on
The system is in the standby mode
For other than the above, see Troubleshooting on page 100.
Note
• You can select "Auto", "High", "Mid" or "Low" for the brightness
of the POWER ON indicator. When "Auto" is selected, the
brightness of the indicator changes to "High", "Mid" or "Low" to
match the brightness level of the viewing area. For details, see
Blue LED Dimmer on page 58.
06
System status
21
En

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Kuro pdp-lx5090h

Inhaltsverzeichnis