Connecting The Power Cord; Attaching The Ferrite Core - Pioneer KURO PDP-LX6090H Bedienungsanleitung

Preparation
Attaching and removing a cable clamp
Thread the clamp band through the holder [1] and bundle the
cable(s) in the cable clamp. Push and hold the levers then insert the
hook into an appropriate hole [2] on the rear of the flat screen TV.
Pull up the clamp band to lock.
2
• Confirm that the cable clamp is seated firmly in the panel.
To remove the clamp band, pull and hold the latch to release.
To remove the cable clamp, push and hold the levers then pull it out
from the hole.
Latch
Note
• Avoid pinching or creating pressure points when routing or
bundling cables.
• The longer a clamp is in place, the better chance of
deterioration. An older clamp is more easily damaged while
being removed and may not be reusable.
• Use the cable clamps as necessary.
• Be careful not to subject any connecting cables to strain.

Attaching the ferrite core

Attach the accessory ferrite core to the end of the power cord as
shown in the accompanying illustration. Use the provided cable tie
to prevent the ferrite core from slipping on the cable.
If you do not do this, the flat screen TV will not conform to
mandatory CE standards.
1
Cable clamp
Lever
Lever
1
2
Ferrite core
To power outlet
AC power cord

Connecting the power cord

T
W
Rear view
Power cord
UK and Republic of Ireland
Note
• Disconnect the power cord from the power outlet when the flat
screen TV is not going to be used for a long period of time.
• Insert the power plug in the AC outlet, after all other
components are connected.
4
3
Cable tie
As close as possible
T
W
Europe, except UK
and Republic of
Ireland
05
19
En