Pioneer KURO PDP-LX6090H Bedienungsanleitung Seite 104

15 Additional information
Problem
OTHER
• POWER ON indicator or
STANDBY indicator is quickly
flashing.
If the following error codes appear on the screen, check the corresponding items in the table.
Code Message
SD04
Powering off. Internal temperature is too high.
Check temperature around the display.
SD05 Internal protection circuits turning power OFF.
Possible short in the speaker cable.
SD11 Powering off. Internal temperature is too high.
Check temperature around TV.
Signal names for 15-pin mini D-sub connecter
Pin No. Signal name
1 R
2 G
3 B
4 Not connected
5 Not connected
6 GND (ground)
7 GND (ground)
8 GND (ground)
104
En
Possible solution
• Internal protective circuits may have been activated. First turn a off on the flat screen TV, wait one
minute or more, then switch the power on again by turning a on. If the indicator is still flashing,
unplug the flat screen TV's power cord from the power outlet. Wait one to two minutes then plug
in the flat screen TV again. If this does not solve the problem, contact a Pioneer Service Center.
These are listed on your warranty card for each country. Alternatively, check the Pioneer Web site
(see back cover) for contact details.
Check
Check if the ambient temperature of the flat screen TV is high.
Check the speaker cable connections between the flat screen
TV and the speakers.
Check if the ambient temperature of the flat screen TV is high.
Pin No. Signal name
9 +5 V
10 GND (ground)
11 Not connected
12 SDA
13 HD
14 VD
15 SCL