Hama KHL 42 Bedienungsanleitung Seite 5

g User manual
This DIN A4-Laminator was specially designed for lami-
nating foils with a thickness between 75 µm and 150 µm.
It can be used for hot and cold lamination of certifi cates,
menus, pictures, etc.
Safety notes:
1. Read all instructions thoroughly before using the
machine.
2. Place the cable in such a way that no one will trip
over it.
3. Never open the housing of the laminator.
4. Do not operate the device if it is wet.
5. Switch the device off after use and remove the plug
from the power supply when the device is not in use.
6. Do not cover the heat openings during use.
7. Do not touch the heat openings during or directly after
operation -> Danger of burns!
8. Do not insert any objects into the device (including into
the heat openings) except the designated fi lm.
9. If the cable, housing, or socket is damaged, do not use
the machine.
10. Wait approx. 3-5 seconds for the fi lm to cool down
before touching it -> Film may be hot!
11. Do not laminate any liquids, gelatins, or other moist
substances that could leak.
Installation/notes:
1. Remove all packaging materials from the device.
2. Place the laminator on a stable, even surface.
3. Connect the power cable to a 220 - 240 V~ outlet.
4. To switch the device on, press the On/Off button on the
right-hand side. The red „Power" light will go on to
show that power supply is functioning.
5. Then turn the dial and select the thickness of the foil
you want to use for laminating. If you want to use a
cold laminate foil, turn the switch to „Cold".
6. The laminator takes approx. 4-6 minutes to warm up.
The „Ready" light turns green when the laminator is
ready to be used.
4
Downloaded from www.Manualslib.com manuals search engine
7. Place the document to be laminated in the appropriate
laminate sleeve, as shown in Fig.1. Leave approx.
3-5 mm of free space at the corners of the sleeve.
Ensure that there is no dust or dirt in the laminate
sleeve.
Fig.1 Fig.2
8. Begin the lamination process. Push the foil into the
opening of the device with the template. Make sure
that the closed sides of the case go into the device
fi rst. The foil automatically passes through the device.
Do not remove the foil until the lamination is complete
(when the foil has completely passed through the
machine).
9. When the lamination process is complete and the
device is no longer needed, switch the device off by
turning the switch to „Off".
Additional notes on use:
1. Always switch the device off and disconnect it from
the power supply when not in use.
2. Do not let the machine run for more than one hour at a
time and allow approx. 15 seconds between two
laminations.
3. Before you store the device in the box, let it cool for at
least 30 minutes.
4. For the best results, use the laminator at normal room
temperature (10-35 °C).
Cold lamination:
Please make sure that the device has completely cooled
down (a temperature below 35 °C) for a cold lamination.
You may only use special cold lamination foils for this.
It is recommended to always do a cold lamination before
doing any hot lamination, when necessary.