Makita 1911B Bedienungsanleitung Seite 6

Removing or installing planer
blades
► Fig.3: 1. Socket wrench 2. Installation bolt
CAUTION:
• Tighten the blade installation bolts carefully
when attaching the blades to the tool. A loose
installation bolt can be dangerous. Always
check to see they are tightened securely.
• Handle the blades very carefully. Use gloves
or rags to protect your fingers or hands when
removing or installing the blades.
• Use only the Makita wrench provided to remove
or install the blades. Failure to do so may result
in overtightening or insufficient tightening of the
installation bolts. This could cause an injury.
To remove the blades on the drum, unscrew the instal-
lation bolts with the socket wrench. The drum cover
For the correct planer blade setting
Your planing surface will end up rough and uneven, unless the blade is set properly and securely. The blade must be
mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base.
Refer to some examples below for proper and improper settings.
(A) Front base (Movable shoe)
(B) Rear base (Stationary shoe)
Correct setting
Nicks in surface
Gouging at start
Gouging at end
Connecting a vacuum cleaner
NOTE: In some countries, the nozzle may not be
included in the tool package as standard accessory.
► Fig.7: 1. Vacuum cleaner
For tool with nozzle
Connect a hose of the vacuum cleaner to the nozzle.
comes off together with the blades.
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Use blades of
the same dimensions and weight, or drum oscillation/
vibration will result, causing poor planing action and,
eventually, tool breakdown.
► Fig.4: 1. Bolt 2. Drum 3. Planer blade 4. Drum
cover 5. Adjust plate
Place the blade on the gauge base so that the blade edge is
perfectly flush with the inside edge of the gauge plate. Place
the adjust plate on the blade, then simply press in the heel of
the adjust plate flush with the back side of the gauge base and
tighten two screws on the adjust plate. Now slip the heel of the
adjust plate into the drum groove, then fit the drum cover on
it. Tighten the installation bolts evenly and alternately with the
socket wrench.
► Fig.5: 1. Adjust plate 2. Screws 3. Heel of adjust
plate 4. Back side of gauge base 5. Blade
edge 6. Planer blade 7. Inside edge of gauge
plate 8. Gauge plate
(A)
(B)
(A)
(B)
(A)
(B)
For tool without nozzle
1. Remove the chip cover from the tool.
2. Install the nozzle on the tool using the screws.
► Fig.8: 1. Nozzle assembly 2. Screwdriver
3. Connect a hose of the vacuum cleaner to the
nozzle.
Nozzle cleaning
Clean the nozzle regularly.
Use a compressed air to clean the clogged nozzle.
6 ENGLISH
Although this side view cannot
show it, the edges of the blades
run perfectly parallel to the rear
base surface.
Cause: One or both blades fails to
have edge parallel to rear
base line.
Cause: One or both blade edges
fails to protrude enough in
relation to rear base line.
Cause: One or both blade edges
protrudes too far in relation
to rear base line.