AEG HC652600EB Benutzerinformation Seite 35

The installation of more than one appli-
ance
1. Put down the dimension of the work-
top cut out and saw it out.
2. Put the appliances one at time on
some soft surface, a blanket for ex-
ample, with the bottom side up.
3. Put the seal stripe around the lower
edge of the appliance along the
outer edge of the glass ceramic.
4.
Loosely screw the fixing plates into
the appropriate holes in the protec-
tive casing.
5. Put the first appliance in the work-
top cut out. Put the connection bar
in the worktop cut out and push up
half of the width against the appli-
ance.
Loosely turn in fixing plates from
6.
below on the worktop and on the
connection bar.
7. Put the subsequent appliance in the
worktop cut out . Make sure that the
front ends of the appliances are on
the same level.
8. Tighten the fixing plate / retaining
grip screws.
9. Seal the gap between the worktop
and appliances and between appli-
ances with silicone.
10.
Put some soapy water on the silicon.
11. Press the rubber shape with some
strength against the glass ceramic
and move it slowly along the space.
12. Do not touch the silicon until it be-
come hard, it can last about a day.
ENGLISH
35