Presetting Stations - Samsung HT-E5500 Benutzerhandbuch

Presetting Stations

Example : Presetting FM 89.10 into memory.
1 . Press the FUNCTION button to select FM.
2 . Press the TUNING/CH (,.) button to
select <89.10>.
3 . Press the TUNER MEMORY button.
• NUMBER flashes on the display.
4 . Press the TUNER MEMORY button again.
• Press the TUNER MEMORY button before
NUMBER disappears from the display on its
own.
• After you press the TUNER MEMORY
button, NUMBER disappears from the
display and the station is stored in memory.
5 . To preset another station, repeat steps 2 to 4.
• To tune in to a preset station, press the
TUNING/CH (,.) button.
About RDS Broadcasting
Using the RDS (Radio Data System) to
receive FM stations
RDS allows FM stations to send an additional
signal along with their regular program signals.
For example, the stations send their station
names, as well as information about what type of
program they broadcast, such as sports or music,
etc.
When tuned to an FM station which provides the
RDS service, the RDS indicator lights up on the
display.
Description on RDS function
• PTY (Program Type) : Displays the type of
program currently being broadcast.
• PS NAME (Program Service Name) : Indicates
the name of broadcasting station and is
composed of 8 characters.
• RT (Radio Text) : Decodes the text broadcast by
a station (if any) and is composed of maximum
64 characters.
HT-E5500_XU_0223.indd 51 HT-E5500_XU_0223.indd 51
• CT (Clock Time) : Decodes the real time clock
from the FM frequency. Some stations may not
transmit PTY, RT or CT information therefore
this may not be displayed in all cases.
• TA (Traffic Announcement) : TA ON/OFF it shows
that the traffic announcement is in progress.
| NOTE |
\ RDS may not operate correctly if the station tuned is not
transmitting RDS signal properly or if the signal strength
is weak.
To show the RDS signals
You can see the RDS signals the station sends on
the display.
Press the RDS DISPLAY button while listening to
an FM station.
• Each time you press the button, the display
change to show you the following information :
PS NAME RT CT Frequency
While searching, <PS NAME> appears
PS
and then the station names will be
(Program
displayed. <NO PS> appears if no
Service)
signal is sent.
While searching, <RT> appears and
RT then text messages the station sends
(RadioText)
will be displayed. <NO RT> appears if
no signal is sent.
Frequency
Station frequency (non-RDS service)
About characters shown in the display
When the display shows PS,or RT signals,the
following characters are used.
• The display window cannot differentiate upper
case and lower case letters and always uses
upper case letters.
• The display window cannot show accented
letters, <A,> for instance, may stands for
accented <A's> like <À, Â, Ä, Á, Å and Ã.>
51
|
English
2012-02-23 오후 2:25:08 2012-02-23 오후 2:25:08