Bluetooth Device - Samsung HT-E5500 Benutzerhandbuch

To connect the Home Cinema to a

Bluetooth device

Bluetooth device
Check if the Bluetooth device supports the
Bluetoothcompliant stereo headset function.
1 . Press the FUNCTION button on the remote
control of product to display the BT message.
• You will see WAIT for 2 seconds and then
READY on the front display of the Home
Cinema.
2 . Select the Bluetooth menu on Bluetooth
device you want to connect. (refer to
Bluetooth device's user manual)
3 . Select the Stereo headset menu on the
Bluetooth device.
• You will see a list of scanned devices.
4 . Select "SamsungHTS-XXXXXX" from the
searched list.
• When the Home Cinema is connected to
the Bluetooth device, the device name of
the connected Bluetooth device, followed
by the Home Cinema will display the
connected device name on the front display.
5 . Play music on the connected device.
• You can listen to the music playing on the
connected Bluetooth device over the Home
Cinema system.
| NOTE |
\ The Home Cinema only supports Middle Quality SBC
data (up to 237kbps@48kHz), and does not support High
Quality SBC data (328kbps@44.1kHz).
\ The AVRCP feature is supported and would work
differently according to another device's specification.
\ Connect only to a Bluetooth device that supports the
A2DP Profile.
\ Only one Bluetooth device can be paired at a time.
\ Search or connection by product may not be performed
properly in the following cases:
HT-E5500_XU_0223.indd 47 HT-E5500_XU_0223.indd 47
- If there emits a strong electric wave around Home
- If several Bluetooth devices are simultaneously paired
- If the Bluetooth device is turned off, not in place, or
5V 500mA
Connect
- Note that such devices as microwave oven, wireless
To disconnect the Bluetooth device from
the Home Cinema
You can disconnect the Home Cinema from the
Bluetooth device. (refer to Bluetooth deivice's
user's manual)
• The Home Cinema will be disconnected.
• When the Home Cinema is disconnected from
the Bluetooth device, the Home Cinema will
display DISCONNECTED on the front display.
To disconnect the Home Cinema from the
Bluetooth device
Press the (
Home Cinema to switch from BT to another mode
or off the Home Cinema.
• Except disconnect through function conversion,
the connected Bluetooth device will wait a
certain time for response from the Home
Cinema before terminating the connection.
(Disconnection time may differ, depending on
the Bluetooth device)
• The currently connected device will be
disconnected.
| NOTE
\ In Bluetooth connection mode, the Bluetooth connection
\ If the Bluetooth device falls back in the effective range,
\ In BT function mode, Screen saver will operate if
Cinema.
with product.
malfunctions.
LAN adapter, plasma bulb and gas stove use the same
frequency range as the Bluetooth device, which can
cause an electric interference.
) button on the front panel of the
|
will be lost if the distance between the Home Cinema
System and the Bluetooth device exceeds (10 meters).
If the distance is returned to the effective range or you
restart the Bluetooth device, you have to reconnect them.
you can restart to restore the pairing with the Bluetooth
device.
the device keep Ready state last 5 minute. Then, for
connecting the BT device, turn off the screen saver and
connect it. To turn off the Screen saver, operate any
button on the remote control. (e.g. Volume button etc.)
47
|
English
2012-02-23 오후 2:24:59 2012-02-23 오후 2:24:59